Carbody spray film DIY spray system, black orange

• FOLIATEC Spray System with paint gun, compressor and special 12 m air hose
• easy application: fill in paint, insert the plug and ready to go
• adjustable spray jet

Application:

• All car parts that can be easily removed should be dismantled. Mask all surfaces that are not to be coated. Mask rubber seals with FOLIATEC Easy Up Tape (item no. 79920). You should also protect wheel housings and the car underbody from spray mist.
• Clean and dry the surface to be sprayed, including edges, then degrease using FOLIATEC Carbody Spray Film Pre-cleaner (item no. 79934). After cleaning, remove the remaining dust with a duster (item no. 79933).
• Application with FOLIATEC spray system: Apply the FOLIATEC Carbody Spray Film in 4 to 5 generous layers. On horizontal surfaces (roof or bonnet), work at a slow pace and at level 1 or 2; set the quantity control on the spray pistol grip to level IIII. On vertical surfaces, work at a medium pace and level 2. If necessary, reduce the quantity control on the spray pistol grip. Only use in suitable workshops and garages. Reduce ventilation if working in a spray booth.
• Application with spray gun: Apply the FOLIATEC Carbody Spray Film in 4 generous layers at medium speed. Use a 2 - 2.5 mm spray nozzle with approx. 2 bar pressure on the spray gun in a suitable spray booth.
• Flash off for 45 - 60 minutes after every spray coating until the wet surface is visibly matt dried.
  Please note: For effect colours, e.g. magic green-purple first apply at least two matt black coats; after approx. 45 - 60 minutes’ drying time, spray on at least two coats of the effect colour.

Notes for RAL colours: first apply at least two transparent coats; drying time between coats: 45 - 60 minutes; after at least 3 hours drying time, spray on at least two coats of the RAL colour.

Hardening: After 1 - 2 hours the Carbody Spray Film is dust-dry. After 24 hours the vehicle is ready to drive again.

For detailed information, check the instruction manual!